NETGEAR GSM7252S Switch Firmware 10.0.0.44
Date: May 20, 2014
Manufacturer: NETGEAR
Fixes:
- Feature request to have java (TCP 4242) in the management ACL list
- Unable to ping the VRRP virtual IP address from a routed interface
- Unable to apply the configure file to the switch after copying it from USB stick
- When running cable test, some empty ports showed 'cable status test failed'
- POE cameras keep rebooting in an endless loop Console hung after session timeout
- DHCP server did not respond in unicast address as requested by the client
- SSH Session Timeout range is different on GUI and CLI
- Feature request to have java (TCP 4242) in the management ACL list
- Unable to ping the VRRP virtual IP address from a routed interface
- Unable to apply the configure file to the switch after copying it from USB stick
- When running cable test, some empty ports showed 'cable status test failed'
- POE cameras keep rebooting in an endless loop Console hung after session timeout
- DHCP server did not respond in unicast address as requested by the client
- SSH Session Timeout range is different on GUI and CLI
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Router / Switch / AP
- COMPATIBLE WITH:
- OS Independent
- file size:
- 15.9 MB
- filename:
- GS72-7300S-FS-PS_V10.0.0.44.zip