NETGEAR FVS336Gv2 Firewall Firmware 4.3.3-6

Bug Fixes:

- Routers that have FAILED their PCI Compliance SCANS.

Known Issues and Limitations:

- [CLI]Device is accepting start IP address is larger than end IP address in IPv6 Address pool table
- Device is not accepting mode config pool IPs for a specific range of addresses through CLI
- Not able to change to IPv4/IPv6 dual mode through CLI.
- Unable to login to the device GUI after configuring custom portal as default
- Device is not showing prefix length for IPv6 WAN address in router status and WAN setup page.
- Sometimes TELNET session to the device is not accessible
- List of services of server group are not displaying in CLI show command.
- Device is not showing proper error message while performing ping and trace route when the selected local gateway WAN is down
- Device is showing error "IP subnet conflicting with WAN1" while adding multihoming IP address when WAN ISP type is PPPoE/PPTP
- Opened ports are getting closed when we make changes to other rules in Port Triggering page.
- Device WAN not able to connect with the Windows PPTP server.
- Not able to establish IPv6 SSL-VPN tunnel from java based browsers with java 8 update 20 version.
- Unable to run the FTP traffic from Filezilla client over SSL Port forwarding tunnel in the Windows7 64 bit host
- Unable to establish Port forwarding tunnel from Windows7 64 bit IE9 browser.
- [SSL VPN] tunnels establishment failed for Windows 8.1 64 bit IE11 browser.
- Link detection processes are seen for WAN3 and WAN4 also but device is having only WAN1 and WAN2.
- Observed critical error when we click on trace route option, if ping though VPN tunnel is selected

About Gateway Firmware:

By applying this firmware, your gateway can receives fixes for various vulnerability issues, support for newly developed technologies, several authentication-related enhancements, as well as other changes.

However, due to the wide variety of gateway models, as well as the large number of manufacturers, in order to perform a firmware update properly, it would be best if you read and understand the installation steps of this specific model.

In addition to that, it is also recommend that this process be initiated in a steady power environment, and only when you have completely familiarized yourself with the upgrade procedure.

Bear in mind that failing to perform a successful update or interrupting the firmware installation in any way can cause serious malfunctions to the gateway, and might even render it unusable.

Therefore, if you intend to install this version, click the download button and apply it to the gateway. To stay up to date with new releases, all you have to do is check back with our website as often as possible.