Silicon image SiI3112/Sil3512 IDE 1.1.0.5

This PCI Host Adapter can upgrade your desktop computer to have dual Serial ATA Channels. It can support both low profile and standard PCI interfaces. The board provides a 32 bit, 33/66 MHz PCI interface on the host side and dual, fully compliant Serial ATA ports on the device side to access Serial ATA storage media such as hard disk drives, floppy disk drives, CD-ROM, CD-RW, DVD-ROM.

Features:

Breaks Capacity-Limit to Support HDD larger than 137GB
Dual high speed Serial ATA interface ports, each supporting 1st generation Serial ATA data rates 1.5Gb/s
Fully compliant with Serial ATA 1.0 specifications
Provides RAID 0 (Stripping) to greatly increase the performance of data transfer by simultaneously writing data to 2 drives
Provides RAID 1 (Mirroring) to protect the data from a disk failure by writing identical data on 2 drives
Supports Spread Spectrum in receiver
Independent 256-byte FIFOs (32 bit * 64 deep) per Serial
ATA channel for host reads and writes
Compliant with PCI Specification, revision 2.2
Integrated PCI DMA engines
32 bit, 33/66MHz fully compliant PCI host interface


Specifications:

Compliant with Serial ATA Specification REV 1.0
Support Serial ATA data transfer rates up to 150MB/sec
Support RAID 0 & RAID 1
Features independent 2560buty FIFOs per channel for host reads and writes
Breaks the 137GB barrier! Supports various brands of large capacity serial ATA hard disk drives
Flexible serial ATA cable is easier to route inside a PC SATA power cable: Connect the S-ATA hard drive and system power supply
Silicon Image SiI3112 SATALink PCI Host Controller
Compliant with Serial ATA specification Rev. 1.0
Slot type: 32-bit PCI
Provides two independent channels to connect up to two serial ATA hard disk drives
Support Serial ATA data transfer rates up to 1.5Gbps