Foxconn nT-435H Chrontel Control Driver 3.4 x86

Specifications:

- Processor: Intel D425 Single core 1.8GHz

- Chipset: Intel NM10 Chipset

- Memory: 1 x SO-DIMM Socket upport DDR3 800 up to 4GB

- VGA Graphics: Intel Graphics Media Accelerator 3150

- Storage Interface: 1x 2.5" SATA II

- LAN: IEEE 802.11b/g/n up to 300Mbps (Dual Antenna)

- Front I/O
1x SD/SDHC/MS/MS Pro/MMC 5 in 1 Card Reader
2x USB 2.0
1x Mic in (support S/PDIF-IN)
1x Headphone

- Back I/O
1x RJ-45 (10Base-T/100Base-T/1000Base-T)
4x USB 2.0
1x Line-out jack.(support S/PDIF-OUT)
1x HDMI
1x VGA
1x DC in


It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.