Gigabyte GA-M68M-S2P NVIDIA SATA RAID Preinstall Driver 15.45 for XP

CPU
1. Support for AM3/AM2+/AM2 processors: AMD Phenom II processor/ AMD Phenom processor/AMD Athlon II processor/ AMD Athlon processor/AMD Sempron processor
* If you install AMD AM3/ AM2+ CPU on AM2 motherboard, the system bus speed will downgrade from HT3.0 (5200MT/s) to HT1.0 (2000 MT/s) spec; however, the frequency of AM3/ AM2+ CPU will not be impacted. Please refer "CPU Support List" for more information.

Hyper Transport Bus
1. 2000 MT/s

Chipset   
1. NVIDIA GeForce 7025/nForce 630a chipset

Memory   
1. 2 x 1.8V DDR2 DIMM sockets supporting up to 8GB of system memory
2. Dual channel memory architecture.
3. Support for DDR2 1066/800/667 MHz memory modules
* DDR2 1066 is supported with combination of AM3/ AM2+ processors and qualified memory modules, please refer "Memory Support List" for detail memory support information.

Audio   
1. Realtek ALC883 codec
2. High Definition Audio
3. 2/4/5.1/7.1-channel
4. Support for S/PDIF In/Out
5. Support for CD In

LAN   
1. Onboard Realtek RTL8211CL (10/100/1000Mbit)

Expansion Slots   
1. 1 x PCI Express x16 slot, running at x16
2. 1 x PCI Express x1 slot
3. 2 x PCI slots

Storage Interface
NVIDIA GeForce 7025/nForce 630a chipset
1. 1 x IDE connector supporting ATA-133/100/66/33 and up to 2 IDE devices
2. 4x SATA 3Gb/s connectors supporting up to 2 SATA 3Gb/s devices
3. Support for SATA RAID 0 and RAID 1

iTE IT8718 chip:
1. 1 x floppy disk drive connector supporting up to 1
2. floppy disk drive

USB
Integrated in the NVIDIA GeForce 7025/nForce 630a chipset
1. Up to 8 USB 2.0/1.1 ports (4 on the back panel, 4 via the USB brackets connected to the internal USB headers)

Internal I/O Connectors   
1. 1 24-pin ATX power connector
2. 1 4-pin ATX 12V power connector
3. 1 floppy connector
4. 1 IDE connectors
5. 4 SATA 3Gb/s connectors
6. 1 CPU fan connector
7. 1 system fan connector
8. 1 front panel connector
9. 1 front panel audio connector
10. 1 x surround/center audio header
11. 1 CD In connector
12. 1 SPDIF In/Out connector
13. 2 USB 2.0/1.1 connectors for additional 4 USB 2.0/1.1 ports by cables
14. 1 Chassis Intrusion connector
15. 1 Power LED connector

Back Panel Connectors   
1. 1 PS/2 keyboard port
2. 1 PS/2 mouse port
3. 1 parallel port
4. 1 x serial port
5. 1 x D-Sub port
6. 4 USB 2.0/1.1 ports
7. 1 RJ-45 port
8. 3 audio jacks (Line In / Line Out / MIC In)

I/O Controller   
1. iTE IT8718 chip

H/W Monitoring   
1. System voltage detection
2. CPU / System temperature detection
3. CPU / System fan speed detection
4. CPU / System warning temperature
5. CPU / System fan failure warning
6. CPU fan speed control

BIOS   
1. 2 x 8 Mbit flash
2. Use of licensed AWARD BIOS
3. Support for DualBIOSTM
4. PnP 1.0a, DMI 2.0, SM BIOS 2.3, ACPI 1.0b

Other Features   
1. Supports @BIOS
2. Supports Q-Flash
3. Support for Xpress BIOS Rescue
4. Supports Download Center
5. Supports Xpress Install
6. Supports Xpress Recovery2
7. Supports EasyTune

Bundle Software   
1. Norton Internet Security (OEM version)

Form Factor   
1. Micro ATX form factor; 24.4cm x 22.5cm



It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.