HP ProLiant MicroServer Gen8 QLogic P3P Multifunction Driver 5.3.26.605
Fixes:
- This driver corrects an issue which can result in lower throughput in a Hyper-V environment using Virtual Machine Queue (VMQ).
- This driver corrects an issue where fewer than the maximum number of VMQs is created.
- This driver corrects an issue which can result in the driver being unloaded after being reset.
- This driver corrects an issue which can result in a Windows Stop Error (BSOD) on a system with insufficient Message Signaled Interrupt – Extended (MSI-X) resources.
- This driver corrects an issue which prevents proper Receive Side Scaling (RSS) distribution on P3 adapters.
- This driver corrects an issue which can result in Large Receive Offload (LRO) failing after the Maximum Transmission Unit (MTU) size being updated.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Network Card
- COMPATIBLE WITH:
- Windows 2008
- file size:
- 4.9 MB
- filename:
- cp020595.exe