Mellanox MHGA28-1SC rev.A1 HCA Card Firmware 4.8.200
New Features:
- Support for programming the PCI Express maximum payload size via the firmware INI file. See the parameter emt_max_payload_size_supported in the file fw-25208-defaults.ref
- Support for log_ge_per_port parameter which is used for assigning gather engines to queues.
- Added the INI parameter watchdog_enable to enable the IB flow control watchdog timer. See the file fw-25208-defaults.ref
- Support for 400 MHz DDR SDRAM DIMMs
Changes to parity error detection mechanism as follows:
- Added the INI parameter pqcp to reduce harmless QP Context array parity errors
- Added a FW mechanism for correcting TPT (Translation & Protection Table) parity errors
Fixes:
- Small message rate degradation
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Network Card
- COMPATIBLE WITH:
- OS Independent
- file size:
- 303 KB
- filename:
- fw-25208-4_8_200-MHGA28-1SC_A1-A3.bin.zip