The Access Point (AP) provides a bridge between Ethernet wired LANs and Intel® PRO/Wireless 2011 LANs. It provides connectivity between Ethernet wired networks and radio-equipped mobile units (MUs). MUs include the full line of Intel terminals, PC Cards and PCI adapters, bar-code scanners, third-party devices, and other devices.

The AP provides a 11 Mbps data transfer rate on the radio network. It monitors Ethernet traffic and forwards appropriate Ethernet messages to MUs over the Intel® PRO/Wireless 2011 LAN. It also monitors MU radio traffic and forwards MU packets to the Ethernet LAN.

The AP meets the following:

*
the regulatory requirements for Europe and many other areas of the world
*
FCC part 15 class A with no external shielding
*
FCC part 15 class B, ETS 300-339 compliance, including CE mark.

The AP has the following features:

*
built-in diagnostics including a power-up self-check
*
built-in dual antenna assembly with optional diversity
*
wireless MAC interface
*
field upgradable Firmware
*
10baseT Ethernet port interface with full-speed filtering
*
power supply IEC connector and a country-specific AC power cable
*
PC/AT Serial Port Interface
*
support for up to 127 mobile units
*
data encryption
*
increased MIB support
*
SNMP support
*
Mobile IP support.
*
DHCP support
*
HTTP Web server support
*
short RF preamble
*
wireless AP

It is highly recommended to always use the most recent driver version available.
Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.