Intel S2600CW Server Board EFI Firmware 01.01.0005

Versions:

- System BIOS - R01.01.0005
- ME Firmware - 03.00.07.114
- BMC Firmware - 01.07.6909
- FRUSDR - 1.02

Update Procedure:

- Unzip the contents of the update package and copy all files to a folder on a USB flash drive
- Insert the USB flash drive to any available USB port on the server system to be updated
- Boot the Server to the uEFI shell. This can be accessed via the <F2> BIOS setup utility during POST or via the <F6> Boot Menu accessed during POST.
- Run the command "map -r" in the uEFI shell to mount the USB flash drive
- Run the command "fs0:" to change folders to the USB flash drive. The USB flash drive may also mount to fs1: depending on other installed devices. The number of "fs#" is dependent on the result of command "map -r"
- Change folders to the folder holding the update package files
- Run the "Startup.nsh" script file to start updating all the firmware and BIOS updates
- The FRUSDR utility must be run separately after the rest of the software stack has been updated, and after the the system has been rebooted. Follow the on-screen instructions provided while running the STARTUP.NSH script file.

NOTE:

- The System BIOS update process in this package will update both the primary and secondary (BIOS Backup) images of the BIOS.
- The secondary image will automatically load after after the primary BIOS has been loaded and the system is rebooted.
- During the first system reboot, while the secondary BIOS is being updated, the display screen will be blank for approximately 60- 90 seconds.
- Do NOT power off or reboot the system during this time.
- When the update is finished, a "BIOS Update Complete" message will be displayed and the system will resume its normal POST process.