- Improves sensor calibration routine that is used when resuming from Standby or Hibernation mode in a D3 power state.
- Enhances finger detection algorithm when the sensor is in Navigation mode.
- Fixes issue where a blank icon is displayed in the Control Panel when using 32-bit images.
It is highly recommended to always use the most recent driver version available.
Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.
Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.