Tenda W300D(v3.0) Router Firmware 1.0.0.4 for New Zealand/Australia
Manufacturer: Tenda
Date: Sep 23, 2013
Notes:
1.Incorrect upgrades will damage your device.
2 .This firmware only fits for users in NewZealand/Australia using firmware version V1.0.0.X or V1.0.X
3.Before upgrading, please record the VPI/VCI value, the correct DSL link type and your access account and password in case of you forget.
4.Please upgrade your modem by cable connections.
5.Do not power your modem off while upgrading.
6.Please unzip the file you downloaded and use the file ended with "bin" or "trx" to upgrade your device.
7.After upgrading, please restore it to factory defaults and configure the device again.
1.Incorrect upgrades will damage your device.
2 .This firmware only fits for users in NewZealand/Australia using firmware version V1.0.0.X or V1.0.X
3.Before upgrading, please record the VPI/VCI value, the correct DSL link type and your access account and password in case of you forget.
4.Please upgrade your modem by cable connections.
5.Do not power your modem off while upgrading.
6.Please unzip the file you downloaded and use the file ended with "bin" or "trx" to upgrade your device.
7.After upgrading, please restore it to factory defaults and configure the device again.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- OS Independent
- file size:
- 3.8 MB
- filename:
- US_W300Dv3Br_1.0.0.4_AUS_en_AUS.rar