Fixes:
- Fixed issue when one of the group is set to ETTL mode, if one of the flash is not recycled, it may make a full output flash due to incorrect light metering. Now YN-E3-RT won't trigger a flash in such a situation. Note: if the group is set to M mode, a flash will be triggered no matter it is recycled or not.
- Improved flash syncing with cameras after 2012.
- Added legacy flash trigger (for non canon cameras). Now you can use YN-E3-RT on non canon cameras with standard iso hot shoe. You need to press test the test button to transfer the M mode parameters.
- Fixed issue when one of the group is set to ETTL mode, if one of the flash is not recycled, it may make a full output flash due to incorrect light metering. Now YN-E3-RT won't trigger a flash in such a situation. Note: if the group is set to M mode, a flash will be triggered no matter it is recycled or not.
- Improved flash syncing with cameras after 2012.
- Added legacy flash trigger (for non canon cameras). Now you can use YN-E3-RT on non canon cameras with standard iso hot shoe. You need to press test the test button to transfer the M mode parameters.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- OS Independent
- file size:
- 151 KB
- filename:
- YN-E3-RT_FW_V1.07.zip