Specifications:

Front panel
1. Socket for the special 13-pin AXON AXK 100 cable (not included) to connect gui-tars/basses with hexaphonic pickup systems (e.g. AXON PU 100 or AXON AIX 101/103).
2. 3-digit 7-segment LED display.
3. TUNER button with multiple functions:
�� TUNE MODE: A minus sign signals that the device is in TUNE mode. Press the button briefly to activate this mode. Pressing the button again will return it to preset mode.
�� FIRMWARE UPDATE: Press the Tuner button and hold it for around 3 seconds while the device is initialising.
�� BRIGHTNESS: Press and hold the button while the device is in operation. The display will first gradually dim, then gradually brighten again. Release the but-ton at the desired level.
4. POWER ON/OFF switches the AC power of the AXON. The LED display is lit when the power is turned on.

Rear panel
1. 12VAC: Connect the power adapter here (12VAC/1.5A).
2. USB: Socket to connect the device to your computer.
3. MIDI IN: The AXON receives all incoming Program Change commands, as well as controller data via this input. A MIDI footswitch to change presets can be connected here.
4. MIDI THRU: All data arriving at MIDI IN is available in unchanged form here.
5. MIDI OUT: All MIDI data generated by your AXON AX 50 USB is available here.
6. INST. OUT: The "normal", unmodified pickup signal of your guitar can be sent through the 13-pin cable, making it available at this socket. The pickups PU 100 and AIX101/103 have an input for the pickup signal of your guitar. Use the included cable to connect the pickup output of your guitar to the minijack socket.


It is highly recommended to always use the most recent driver version available.
Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.