Silicon Power Field Updater 1.36/S80 SSD Firmware 6.00

Before Use:

- Updating your device may result in data loss, therefore, we strongly recommend you back up your data before proceeding.
- Please DO NOT unplug the device or the power source during firmware update. This may cause unpredictable damage.
- Use only native SATA ports to perform upgrade. Do NOT use third party controllers

Note:

- Microsoft AHCI driver is required and Microsoft AHCI mode must be enabled on your computer.
- You must have Administrator privileges on your computer to run this utility.
- If update failed, please help try to demount the IRST mode

Installation Steps:

- Connect the Silicon-Power SSD to your PC or laptop. (To be used SATA interface directly. Do not used USB HUB)
- Double click the icon “SSD FieldUpdater v12 for Windows.exe” to launch the utility.
- SSD Firmware Update Utility will automatically scan for all devices and list them in the main window
- Select one or more desired drives to update. If two or more drives need to be updated at the same time, please ensure that the last five digits of each selected drive in the Signature column are identical to each other or the update will fail.
- Check the box next to the desired drive(s) and click “Update firmware…”
- Select the corresponding signature firmware file (.VIC), and click Open.
- A warning message window will pop up. Please ensure that all of your data stored on the drive(s) is backed up and then select “Proceed” to continue the update process. Click “Cancel” to exit the utility and back up your data if you have not already done so.
- Once the update has completed successfully, a green check mark will appear on the disk icon.
- Click “Rescan For Drives” to confirm that the SSD firmware has been updated successfully.