Fixes:
- Modify the camera setup for flash power ratio output.
- Modify support FEB function.
- Modify the compatibility of camera, such as60D, 5D Mark III.
- Modify the test flash output mode, such as flash under E-TTL mode, pre-flash ratio output. Under M mode, the output ratio is according to the flash setting.
- The modification can support the zoom settings, M mode and ETTL mode on flash
- Modify the camera setup for flash power ratio output.
- Modify support FEB function.
- Modify the compatibility of camera, such as60D, 5D Mark III.
- Modify the test flash output mode, such as flash under E-TTL mode, pre-flash ratio output. Under M mode, the output ratio is according to the flash setting.
- The modification can support the zoom settings, M mode and ETTL mode on flash
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.