NETGEAR WG302v2 Wireless Access Point Firmware 5.2.3

Fixes:
WPA-PSK/WPA2-PSK support for Wireless Bridging and Repeating.Dynamic VLAN support – VLAN assignment to wireless clients based on Radius server settings ( RFC 2868).Configurable Management VLAN.

Bug Fixes:

Fixed: Station list does not display the associated wireless client's IP when DHCP server is enabled.Fixed: WEP is not supported with 802.1X.Fixed: Cannot connect WG302v2 with WPA2-PSK only Security.Fixed: User-Name from the Accept-Accept packet is not used in accounting (usage monitoring) Acct-Req (recommendation from RFC2865).Fixed: Accounting records are missing a few entries.Fixed: Setting the channel policy to accept best policy mode via SNMP.Fixed: WPA station and group key rotation causes stations to disconnet.


It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.