Fixes:
- Added “Preamp Tube Type” parameter to Amp block. “Modern” (default) selects a triode characteristic representative of modern production tubes. “Vintage” selects a characteristic typical of tubes produced in the 50’s and 60’s. “Long Plate” replicates the softer saturation characteristic of so-called “Long Plate” triodes.
- Fixed drive network high-pass filter in Amp block not being reset properly when switching between certain models.
- Fixed wrong Crunch default value and associated constants in Angle Severe amp models.
- Fixed Pedal Compressor types not compensating for compression amount thereby requiring manual level compensation.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- OS Independent
- file size:
- 4.4 MB
- filename:
- axefx2_18p04.zip
- Newer! Fractal Audio Axe-Fx II Mark I Preamplifier Firmware 19.002015-06-25
- Newer! Fractal Audio Axe-Fx II Mark I Preamplifier Firmware 18.082015-04-27
- Newer! Fractal Audio Axe-Fx II Mark I Preamplifier Firmware 18.02015-04-16
- Newer! Fractal Audio Axe-Fx II Mark I Preamplifier Firmware 18.062015-04-08
- Fractal Audio Axe-Fx II Mark I Preamplifier Firmware 18.042015-03-30
- Fractal Audio Axe-Fx II Mark I Preamplifier Firmware 18.032015-03-26
- Fractal Audio Axe-Fx II Mark I Preamplifier Firmware 18.012015-03-16
- Fractal Audio Axe-Fx II Mark I Preamplifier Firmware 17.042015-01-14
- Fractal Audio Axe-Fx II Mark I Preamplifier Firmware 17.002014-12-04
- Fractal Audio Axe-Fx II Mark I Preamplifier Firmware 16.04.12014-11-12