Fixes:
- Camera settings can now be viewed and changed using the WR-1 when the WR-1 is used as a transmitter and the WR-R10 is connected to a D7100 for use as a receiver.
- Support for the Release Hold Time function built into the WR-1 is now supported when the WR-1 is used as a transmitter and the WR-R10 is used as a receiver.
- To make remote operation using the WR-1 function that allows for division of multiple units into groups (A, B, C, D) more convenient, the group specified with the WR-R10 is now fixed at group A rather than all groups (A, B, C, D) with transmission. With reception, the group is fixed at group A with firmware versions 1.00 and 2.00.
- Camera settings can now be viewed and changed using the WR-1 when the WR-1 is used as a transmitter and the WR-R10 is connected to a D7100 for use as a receiver.
- Support for the Release Hold Time function built into the WR-1 is now supported when the WR-1 is used as a transmitter and the WR-R10 is used as a receiver.
- To make remote operation using the WR-1 function that allows for division of multiple units into groups (A, B, C, D) more convenient, the group specified with the WR-R10 is now fixed at group A rather than all groups (A, B, C, D) with transmission. With reception, the group is fixed at group A with firmware versions 1.00 and 2.00.
Only the camera indicated below can be used to upgrade WR-R10 firmware:
- D7100 DSLR
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- Windows XP
Windows Vista
Windows XP 64 bit
Windows Vista 64 bit
Windows 7
Windows 7 64 bit
Windows 8
Windows 8 64 bit - file size:
- 126 KB
- filename:
- F-WRR10-V200W.exe