Fixes:
- When the shooting data for RAW images was viewed with software such as Nikon View, “7” was always displayed for the second digit in two-digit numbers in the date and time of recording information. This problem has been corrected.
- When adjustments were made to “Metering” for User Set 1, 2 or 3, camera setting switched to a different User Set and the camera turned off, the previously applied Metering setting was changed when the camera was again turned on. This problem has been corrected.
- When RAW images were reviewed in the camera monitor in Quick Review or Playback mode with playback zoom applied and shooting information then switched off or on, image display was irregular when a playback zoom operation was again performed. This problem has been corrected.
- When the shooting data for RAW images was viewed with software such as Nikon View, “7” was always displayed for the second digit in two-digit numbers in the date and time of recording information. This problem has been corrected.
- When adjustments were made to “Metering” for User Set 1, 2 or 3, camera setting switched to a different User Set and the camera turned off, the previously applied Metering setting was changed when the camera was again turned on. This problem has been corrected.
- When RAW images were reviewed in the camera monitor in Quick Review or Playback mode with playback zoom applied and shooting information then switched off or on, image display was irregular when a playback zoom operation was again performed. This problem has been corrected.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- Windows All
- file size:
- 685 KB
- filename:
- CP5700fw11.zip