- When shooting with the "Vibration Reduction" item in the setup menu set to "On", vibration reduction did not always function in the following situations. This issue has been resolved.
When the camera was turned on, or with 'recovery from standby mode' (activated by the "Auto-off" function), and the electronic viewfinder display enabled by pressing the monitor button.
When the camera was turned on, or with recovery from standby mode (activated by the "Auto-off" function), and the camera connected to a televison or other video device via the supplied audio/video cable (EG-CP14)
- When shooting with the "Distortion Control" option set to on, excessive correction was sometimes applied. This issue has been resolved.
It is highly recommended to always use the most recent driver version available.
Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.
Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.