Fixes:
- PHY firmware update.
- The Product Registration feature is supported. It will guide user to register Netgear switch when user login the switch through GUI first time.
- With multicast routing enabled, port disconnect/connect will stop MC traffic by 20 sec.
- Multicast packet loss seen if the client joins before multicast streaming starts.
- 10G port doesn't link up 'after clear configure'.
- Link flapping when connecting laptop to XSM7224S Gig Port.
- XSM7224S crashed after issue "clear arp-cache" through telnet.
- Port 21-24 SFP 1G mode auto negotiation fail with IXIA and Port 1-20 SFP force 1G mode link fail with IXIA.
- Remove "ipv6 forwarding" from GUI since "ipv6 forwarding" command deprecated from 9.0.1.
- PHY firmware update.
- The Product Registration feature is supported. It will guide user to register Netgear switch when user login the switch through GUI first time.
- With multicast routing enabled, port disconnect/connect will stop MC traffic by 20 sec.
- Multicast packet loss seen if the client joins before multicast streaming starts.
- 10G port doesn't link up 'after clear configure'.
- Link flapping when connecting laptop to XSM7224S Gig Port.
- XSM7224S crashed after issue "clear arp-cache" through telnet.
- Port 21-24 SFP 1G mode auto negotiation fail with IXIA and Port 1-20 SFP force 1G mode link fail with IXIA.
- Remove "ipv6 forwarding" from GUI since "ipv6 forwarding" command deprecated from 9.0.1.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- OS Independent
- file size:
- 10.8 MB
- filename:
- XSM7224S Firmware version v9.0.1.21.zip
Other versions
OS Independent