NETGEAR XSM7224S Switch Firmware 9.0.0.14

  n/a
Manufacturer:

Description

DOWNLOAD NOW

Fixes:
- Sometime copper port on the combo port may not come up quick enough after switch rebooted. The startup time now is improved.
- The SNTP client source port doesn't take effect after it has being reconfigured.
- The command 'vlan participation all include xxx' on config mode doesn't include all ports in the VLAN actually.
- Stack port flashing for a while when booting up, then stack members reboot automatically due to timeout.
- Device view doesn't display switch information correctly.
- Fails to show master/next/full stack device view.
- Configured LAG name lost after reloading.
- Layer3 traffic over a LAG group fails to switch to another member port if shutdown one of the LAG member that carries the traffic.
- Using GUI to configure Captive Portal, the switch crashed.
- Fail to enable port security on LAG.
- Different private group can communicate.
- XSM7224S provides differen ifName and LLDP Port Id.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

NETGEAR XSM7224S Managed Switch Firmware NETGEAR XSM7224S ProSafe Switch Firmware NETGEAR XSM7224S Gigabit Switch Firmware XSM7224S Firmware NETGEAR Switch

  CATEGORY:
Firmware
  COMPATIBLE WITH:
OS Independent
  file size:
9.9 MB
  filename:
XSM7224S Firmware version v9.0.0.14.zip