NETGEAR GSM7312 Switch Firmware 6.2.0.14

Fixes:
- Add support for new POE switch FSM7328PS
- Add “save” command allows saving running config into flash with a single command
- Add “show running config interface” shows the configuration per interface
- Configure certain IGMP snooping using Web GUI, the switch might crash
- FSM7300S: Unable to bind MAC ACL list to the interface
- FSM7300S: IP ACL does not work properly
- FSM7300S: “show interface” command right after the switch is rebooted will cause the crash
- SNMP v3 packet might cause the switch to crash
- GSM7312 crashes when the client address is blank in SNMP Community config
- SNTP Server Configuration pageAddress Type" field is mistakenly configured as "DNS", device fails to update the time
- VLAN GUI config page is error in not highlighting the member
- GSM7328FS: fiber SFP link not up after module remove and reinsert
- GSM7300S/FS - master unit reboot intermittently
- GSM7300S/FS: eventlog shows corrupted entry
- FSM7326P: IGMP Snooping: 'ip igmpsnooping unknown-multicast filter' does not take effect
- When device originates ARP request for the target in secondary network with Sender IP Address as Primary Interface
- When using default IP address in network interface, copy command failed
- MFDB table do not get updated when client send IGMP leave
- The speed for the port for 1G SFP module is shown to be unknown when specific port is selected on port configuration web page
- Fails to accept host name begins with digit (0-9).
- GUI : garbage character appear when configuring policy map
- Dot1x : access fail after changing port-control from auto to force-authorized
- Port security may impede MAC address learning
- GSM7328S crashed when combo port mode is set to speed of 100Mbps
- GSM7328S could not set 100Mbps half-duplex for gigabit port
- GSM7328S port status stayed down when both sides port mode are set at 1000Mbps full-duplex.