Intel S1200V3RPS Server Board EFI Firmware 01.04.0002

Versions:

- BIOS : R01.04.0002
- ME : R03.00.05.068
- BMC : 1.10.5637
- FRUSDR : 1.06

BIOS Changes in Release 01.04.0002:

- Fixed: Unexpected event logged when heating the PCH with heat gun.
- Fixed: The system will hang at POST Code 0xB2 with add-on video card after "Primary Display" BIOS setting is changed to "Onboard Video".
- Fixed: If process cannot support VT-d, Intel(R) VT for directed I/O Option is visible.
- Fixed: The NIC1/NIC2 controller option cannot be saved to "Disabled" in BIOS setup menu.
- Fixed: Internal Graphic of the Intel(R) Processor G1820T doesn't work on the Intel(R) Server Board S1200V3RPM.
- Fixed: The read/write speed of USB3.0 device cannot reache the right speed when connected to USB3.0 port.
- Fixed: If AC lost occurs during BIOS update, the system may not be recovered via BIOS recovery method.
- Fixed: When windows running in S3+S5 mode and shutting down the system, the system will reboot.
- Fixed: Sometimes the system will reboot after shutting down the system in windows.

ME Changes in Release 03.00.05.068 :

- Fixed: "Firmware Update In Progress bit does not set in FW Status register during online update.
- Fixed: ME-BIOS Interface major and minor version swapped on EFI and DOS.
- Fixed: The Mode Manager does not support reading power from HSC, when the LM25066i chip is used.
- Fixed: After ME reset (Cold Reset command, or any host reset in S0/S1 Only power mode except host warm reset) ME returns incorrect version and CRC of mPhy settings (0). This causes the BIOS to perform (unnecessary) mPhy settings update in ME, which gets rejected with 0x101E error code while it should be accepted.
- Fixed: Sporadically on some platforms ME may be reset during host booting due to internal exception.
- Fixed: Read mPhy settings HECI message returns ICC_STATUS_FAILURE (0x0001) ICC Status field.
- Fixed: PCH register SECRT98 (SATA Electrical Control Register T98) has improper value due to incorrect mPhy settings value in ME. As a workaround the BIOS may force update of these settings during boot.

BMC Changes in Release 01.10.5637:

- Fixed: The BMC may corrupt within 10 DC cycles on the Intel(R) Server board S1200V3RPM.

FRUSDR Changes in Release 1.06:

- Update FRUSDR utility to 12.0 build5