Engenius ESR1221N Router Firmware 1.1.0

Specifications:

RF Specifications
- Frequency Band 2.400–2.484 GHz
- Modulation Technology OFDM: BPSK, QPSK, 16-QAM, 64-QAM
- DBPSK, DQPSK, CCK
- Operation Channels 11 for North America, 14 for Japan, 13 for Europe
Wireless Mode 11b/11g/11n
- Channel Selection (Setting varies by Country)
- Channel Bandwidth (Auto, 20Mhz, 40Mhz)
- Transmission Rate 11g: Best. 54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, 1 in Mbps

Receive Sensitivity
- IEEE 802.11n  up to -85dBm
- IEEE 802.11g  up to -88dBm
- IEEE 802.11b  up to -90dBm

Available Transmit Power
- IEEE 802.11n  up to18dBm
- IEEE 802.11g  up to 18dBm
- IEEE 802.11b  up to 19dBm

Software Features
- Topology Infrastructure
- Operation Mode AP/Router
- LAN
- DHCP Server
- Static Routing Table
- UPNP
- WAN PPTP • PPPoE • Static IP • DHCP Client • Clone MAC address

Router
- NAT/ NAPT
- Static Routing
- Dynamic Route
- Virtual server mapping
- IP address mapping
- Port Forwarding
- Port Triggering
- Special application
- DNS Relay
- DDNS
- Time Zone(NTP client)

Firewall
- Block ICMP Ping
- DoS(Block ICMP Ping, Port scan, Sync Flood)
- MAC/IP Filtering
- ICMP Blocking
- SPI (Stateful Packet Inspection)
- DMZ (Demilitarized Zone) Host
- Policy Based Parental Controls
- Port Range / Service Filtering
- Internet Domain Restriction

VPN VPN pass-through (PPTP, L2TP, IPSEC)

Wireless
- Power saving(Green technology)
- 64/128 bit WEP Encryption
- WPA Personal (WPA-PSK using TKIP or AES)
- WPA Enterprise (WPA-EAP using TKIP)
- 802.1x Authenticator
- Hide SSID in beacons
- Wi-Fi Protection Setup (WPS)
- WDS
- ACL control
- Best Channel selection
- Speed/Bandwidth monitor

QoS
- WMM
- Application base
- Priority Queue
- Bandwidth Allocation


It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.