EnGenius ENH202 Access Point Firmware 1.1.0

Wireless Outdoor 800mW Long-Range Multiple Client Bridge/AP

SPECIFICATIONS:
Hardware Specifications
MCU: Atheros AR7240
Memory: 32 MB
Flash: 8 MB
Physical Interface: 10/100 Fast Ethernet port x 2
One Reset button
LED’s Status:
Power (Status)
LAN1/LAN2 (10/100Mbps)
WLAN (Wireless is up)
3 x Link Quality (Client Bridge mode)
Power requirements:
Active Ethernet: (Power over Ethernet) Proprietary PoE design
Power Adapter: 24VAC / 0.6A

RF SPECIFICATIONS:
Wireless standard
IEEE802.11 b/g/n
Frequency Band: 2.412 ~ 2.472GH (b/g/n)
Modulation Technologies: IEEE 802.11b: DBQSK, DQPSK, CCK
IEEE 802.11g: BQSK, QPSK, 16-QAM, 64-QAM
IEEE 802.11n: BQSK, QPSK, 16-QAM, 64-QAM
Operating Channels:
11 channels

Transmit/Recieve Power
Antenna: Internal Antenna x 2 
Antenna gain: 10 dBi
Frequency Band Range: 2.4 GHz ~ 2.5 GHz
Horizontal Beam width: 70°
Vertical Beam width: 21°
Antenna Polarity: Dual-Polarized: Vertical/Horinzontal
This product does not include an external antenna connector.

SOFTWARE FEATURES:
Topology: Infrastructure
Protocol: IEEE802.3, 802.3U, 802.11 b/g/n (2.4 GHz)
Operation mode: Client Bridge/Access Point/WDS bridge/Client Router
Service: DHCP server/client
VPN: VPN Pass-through
Networking: PPPoE, PPTP
Narrow bandwidth (selectable 5MHz/10MHz/20MHz/40MHz )

MANAGEMENT:
Firmware upgrade: Reset & Backup, Ping & Trace Route
MIB: MIB I, MIB II(RFC1213), Private MIB
SNMP: SNMP v1, v2c
Security:
WEP Encryption-64/128/152 bit
WPA/WPA2 Personal (WPA-PSK using TKIP or AES)
WPA/WPA2 Enterprise (WPA-EAP using TKIP)
802.1x Authenticator
Hide SSID in beacons
MAC address filtering, up to 50 field
Wireless STA (Client) connected list
QoS: WMM (Wi-Fi Multimedia)

ENVIRONMENT & PHYSICAL:
Temperature Range
Operating: -20°C to 70°C (-4°F to 158°F)
Storage: -30°C to 80°C (-22°F to 176°F)
Humidity (non-condensing): 0%～90% typical
Dimensions: Length: 10.24” (260mm) x Width: 3.31” (84mm) x Height: 2.17” (55mm)
Weight: 0.9 Ib
Certifications: FCC, CE, IC



It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.