EnGenius EAP9550 Access Point Firmware 1.3.0

Wireless N 300Mbps Access Point / Universal Repeater with Smoke Detector Design & 802.3af PoE

HARDWARE SPECIFICATIONS:
MCU: RT3052
Memory: 32MB SDRAM
Flash: 4MB
Physical Interface:
LAN One 10/100 Fast Ethernet RJ-45
Reset Button
Power Jack
LEDs Status:
Power (Status)
LAN (10/100Mbps)
WLAN (Wireless Connection)
Power Requirements:
Power Supply: 90 to 240VDC ± 10%, 50/60Hz (Depends on different countries)
Active Ethernet: (Power-over-Ethernet, IEEE 802.3af) 48VDC/0.375A
Device: 12V/1A
Regulation Certifications: FCC Part 15, UL, CE

RF SPECIFICATIONS:
Frequency Band: 2.400~2.484GHz
Media Access Protocol: Carrier Sense Multiple Access with Collision Avoidance (CSMA/CA)
Modulation Technology: OFDM: BPSK, QPSK, 16-QAM, 64-QAM, DBPSK, DQPSK, CCK
Operating Channels: 11 for North America, 14 for Japan, 13 for Europe
Receive Sensitivity (Typical):
IEEE 802.11n
MCS8 @ -90dBm
MCS15 @ -70dBm
IEEE 802.11g
6Mbps @ -92dBm
54Mbps @ -72dBm
IEEE 802.11b
1Mbps @ -93dBm
11Mbps @ -89dBm
Available Transmit Power:
IEEE 802.11n/g
18dBm @ 6~9Mbps / MCS9
16dBm @ 12~18Mbps / MCS11
14dBm @ 24~36Mbps / MCS13
13dBm @ 48~54Mbps / MCS15
IEEE 802.11b
17.5dBm @ 1~11Mbps
Antenna: Directional Embedded Antenna x2; Peak Gain 4dBi
Standard: IEEE 802.11n & 802.11b/g
Frequency Range: 2.4 to 2.49GHz
V.S.W.R.: 2:1
Feed Impedance: 50Ohm
Power Handling: 30dBm
Interface: Two sets of soldering pads for 50ohm, 1.13mm diameter, micor coax cable
Antenna Dimensions: 100mm x 50mm
Weight: 0.03oz (9g)

SOFTWARE FEATURES:
Topology: Infrastructure
Operation Mode: Access Point / Universal Repeater / WDS
LAN: DHCP Server / DHCP Client
Wireless:
Wireless Mode 802.11b / 802.11g / 802.11n
Signal Strength
Bandwidth Selection 40/20MHz
Transmission Rate
802.11b/g: 54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, 1 in Mbps
802.11n: See Below Chart
Guard Interval 800ns
Guard Interval 400ns

Security:
WEP Encryption 64/128bits
WPA Personal (WPA-PSK using TKIP or AES)
WPA Enterprise (WPA-EAP using TKIP)
802.1x Authenticator
Hide SSID in Beacons
Multiple SSID with 802.1q VLAN Tagging (up to 4 SSID)(Access Point mode)
MAC Filter (Access Point mode)
WLAN L2 Isolation (Access Point mode)
Wireless STA (Client) Connected List
QoS: WMM

MANAGEMENT:
Configuration: Web-Based Configuration (HTTP) / Telnet
Firmware Upgrade: Upgrade Firmware via Web Browser; Keep Latest Setting When Firmware Update
Administrator Setting: Administrator Password Change
Reset Setting: Reboot (Press 1 second) / Reset to Factory Default (Press 10 seconds)
System Monitoring: Status, Statistics and Event Log
SNMP: V1, V2c
MIB: MIB I, MIB II (RFC1213), and Private MIB
Traffic Measurement: Per Interface
Bandwidth Measurement: IP Range & Bandwidth Management
Backup & Restore: Settings Through Web

ENVIRONMENT & PHYSICAL:
Temperature Range: Operation 0°C to 45°C (32°F to 113°F) / Storage -20°C to 70°C (-4°F to 158°F)
Humidity (Non-condensing): 0% ~ 95% Typical
Dimensions: Diameter: 120mm (4.72”) x Height: 50mm (2.17”)
Weight: 0.62lb. (280g)