D-Link DSL-2750B (rev.B1) Router Firmware 2.02(EU)

Fixes:

- Added:Enable IPv6 function
- Added:Enable the ETH WAN
- Added:ping test page
- Added:Budget Quota
- Added:USB
- Added:Support config TR69 connection setting from DCC.
- Added:Remote Access, FTP LAN option default to 1
- Fixed:no USB help information bug.
- Fixed:Volume cannot be selected, reboot DUT bug.
- Fixed:page error on budget page
- Fixed:Traffic Information window error on budget page
- Fixed:Cannot establish a 3G connection.
- Fixed:UI will be blank when setup a 3G interface
- Fixed:The Southern Hemisphere Daylight Saving Offset end time should be earlier than start time
- Fixed:PPP with Static IP cannot work.
- Fixed:Group key interval is incorrect.
- Fixed:DNS status display issue
- Fixed:Help info in wizard is wrong.
- Fixed:DUT should not allow PPP IP extension when static IP.
- Fixed:port forward page not check LAN IP
- Fixed:IGMP Picture Quality is poor
- Fixed:PoPup message error when add a static route.
- Fixed:[D-Link] Italian GUI Internet Wizard VPI Value JavaScript Misjudgment Issue
- Fixed:Isp List update

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn't either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn't be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don't always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you're looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don't power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don't miss the update that will improve your device.