D-Link DGS-1100-16 rev.A1 EasySmart Switch Firmware 1.10.008
Manufacturer: D-Link
Date: Jun 20, 2013
How to update your firmware using the Web UI:
- Connect a workstation installed with java SE runtime environment to any switch port of the device.
- Open the web browser from the workstation and enter the IP address of the switch. The switch’s default IP address is 10.90.90.90.
- Enter administrator’s password when prompted. The password is admin by default.
- To update switch's firmware or configuration file, select Tools > Firmware Backup & Upgrade from the banner.
- Click Browse to browse your inventories for a saved firmware file, and then click Upgrade after selecting the firmware file you want to restore.
- Wait until the “Firmware Upgrade Successful” message pops up and login again after device boots up.
- Connect a workstation installed with java SE runtime environment to any switch port of the device.
- Open the web browser from the workstation and enter the IP address of the switch. The switch’s default IP address is 10.90.90.90.
- Enter administrator’s password when prompted. The password is admin by default.
- To update switch's firmware or configuration file, select Tools > Firmware Backup & Upgrade from the banner.
- Click Browse to browse your inventories for a saved firmware file, and then click Upgrade after selecting the firmware file you want to restore.
- Wait until the “Firmware Upgrade Successful” message pops up and login again after device boots up.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- Windows All
- file size:
- 507 KB
- filename:
- DGS-1100_fw_revA1_1.10.008_all_en_20121004.zip