Fixes:
- Adjust TX power base on D-Link WiFi Frequency table
- Fix MSSID missed too many beacons in WPA+OPEN security
- Fix auto channel selection work failed in Multi-SSID
- Fix WDS scanning caused data link break in WDS mode
- Fix APC scanning caused data link break in AP client mode
- Fix AP array endurance issue
- Fix AP client mode low throughput issue.
- Fix Low throughput issue in noise environment.
- Fix AP can't switch to HT20 mode when detect leagcy 11g device.
- Fix kernel panic caused by DHCP pkts forwarding in bridge.
- Fix Hostpad crash issue when authentication type as 802.1X.
- Fix a compatibility issue with Moto MC50 WinCE device in WPA/PSK mode.
- Fix a Static IP assignment issue in WEBUI.
- Fix WLAN module restart frequently when set as dynamic IP.
- Fix memory leak issue in SNMP module.
- Modify output power table (follow D-Link WiFi Frequency table)
- Adjust TX power base on D-Link WiFi Frequency table
- Fix MSSID missed too many beacons in WPA+OPEN security
- Fix auto channel selection work failed in Multi-SSID
- Fix WDS scanning caused data link break in WDS mode
- Fix APC scanning caused data link break in AP client mode
- Fix AP array endurance issue
- Fix AP client mode low throughput issue.
- Fix Low throughput issue in noise environment.
- Fix AP can't switch to HT20 mode when detect leagcy 11g device.
- Fix kernel panic caused by DHCP pkts forwarding in bridge.
- Fix Hostpad crash issue when authentication type as 802.1X.
- Fix a compatibility issue with Moto MC50 WinCE device in WPA/PSK mode.
- Fix a Static IP assignment issue in WEBUI.
- Fix WLAN module restart frequently when set as dynamic IP.
- Fix memory leak issue in SNMP module.
- Modify output power table (follow D-Link WiFi Frequency table)
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- Windows All
- file size:
- 5.4 MB
- filename:
- DAP-2360_fw_revALL_1-10-rc041_all_en_20121106.zip