Cisco WAP4410N Access Point Firmware 2.0.5.3
Date: Jan 12, 2014
Manufacturer: Cisco
Fixes:
- Wireless isolation functionality between (and within) SSIDs is now fixed.
- Fixed inability to assign static IPv6 address using the web-based configuration utility
- Added a separate IP-type setting option for IPv6 in the web-based configuration utility
- WPS can now be disabled using SSH
- WPS is disabled by default. However, a factory reset must be performed first - either press the Reset button for approximately 10 seconds, or use the web-based utility. Alternatively, you may choose to disable WPS using SSH
- Wireless isolation functionality between (and within) SSIDs is now fixed.
- Fixed inability to assign static IPv6 address using the web-based configuration utility
- Added a separate IP-type setting option for IPv6 in the web-based configuration utility
- WPS can now be disabled using SSH
- WPS is disabled by default. However, a factory reset must be performed first - either press the Reset button for approximately 10 seconds, or use the web-based utility. Alternatively, you may choose to disable WPS using SSH
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.