Cisco Linksys E1200 Router Firmware 2.0.02 Build 3

Fixes:
- Added control to the browser-based GUI, so that a user can manually enable/disable Wi-Fi Protected Setup.
- Resolved interoperability issue with ISP DHCP server that mandates client identifier option (option 61).
- Resolved issue with sending broadcast DHCP renewal message. The correct behavior is sending unicast message.
- Allow value of 255 in the 4th octet of L2TP server IP address.

Note:
- This firmware is only compatible with hardware version 2 (v2), but not with hardware version 1 (v1).

It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.