BIOS 1.04 Updates:
- Fix memory timing auto table error
- Add CPU voltage auto table
- Fix BCLK lock after change DIMM or CPU
- Improve memory compatibility and performance
- Fix PXE boot
- Fix DVI to Analog compatibility
- Improve overclocking
- Fix USB device wake from S5
- Improve mouse compatibility
- Fix system reset when disable LAN and BCLK set 125
Windows Installation:
- Download the correct .zip file for your motherboard
- First go into your BIOS and load defaults, save and exit
- Close all open programs.
- Go into the folder where you unzipped this package and update.bat
- Press Y to start the flash process
- DO NOT TURN OFF POWER OR RESET DURING THE FLASH PROCESS
- After the flashing is finished, the system will automatically shut down. Then power on again and go into BIOS to setup.
- NOTE: If flash box immediately closes after flash attempt, the flash may need to be ran from a CMD prompt with administrator privileges or DOS version.
BIOS Installation:
- Extract the contents of .zip file to USB flash drive (must be formatted as FAT32)
- Reboot the machine and go into the system BIOS
- From the BIOS, navigate to the Save & Exit tab and open "Select BIOS File."
- Select the .bin file you wish to flash.
- After the flashing is finished, shut the system down completely. Then power on again.
- After flashing verify that the correct flash was applied by checking the version number on the lower right corner of the BIOS screen.