BIOS Update:

1.Fixed set setup CPU FSB value to 266 MHz when resume from S3, the CPU FSB will be reduced to 177 MHz.
2.Fixed FSB 200 CPU set to 200, after defaults load system can't boot.
3.Fixed FSB 266 CPU can't boot problem.


Technical Specs:

CPU


# LGA 775 socket for: - Intel® Pentium® D - Intel® Pentium® 4 - Intel® Celeron D - Intel® Core2 (Conroe family) - Intel® Quad Core processor(Kentsfield)ready
# Supports Intel Enhanced Memory 64 Technology (EMT64T)
# Supports Enhanced Intel SpeedStep Technology (EIST)
# Supports Intel Hyper-Threading Technology
# Supports 1066/800/533MHz FSB

Chipset


# Intel® 975X Express Chipset - North bridge: Intel® 975X - South bridge: Intel® ICH7R

Memory


# Four 240-pin DDR2 DIMM sockets
# Supports DDR2 533, DDR2 667 and DDR2 800 DIMMs
# Supports dual channel (128-bit wide) memory interface
# Supports up to 8GB system memory

Expansion Slots


# 2 PCI Express x16 slots - CrossFire mode: The two x16 slots each operate at x8 bandwidth. - Single VGA mode: Supports only one x16 slot operating at x16 bandwidth.
# 1 PCI Express x1 slot
# 1 PCI Express x4 slot
# 2 PCI slots

BIOS


# Award BIOS
# 8Mbit flash memory

Power Management


# ACPI and OS Directed Power Management
# ACPI STR (Suspend to RAM) function
# Wake-On-PS/2 Keyboard/Mouse
# Wake-On-USB Keyboard/Mouse
# Wake-On-LAN
# Wake-On-Ring
# RTC timer to power-on the system
# AC power failure recovery

Hardware Monitor


# Monitors CPU / system / north bridge temperature and overheat alarm
# Monitors Vcore/Vdimm/Vnb/VCC5/12V/V5sb/Vbat voltages
# Monitors the speed of the cooling fans
# CPU Overheat Protection function monitors CPU temperature and fan during system boot-up - automatic shutdown upon system overheat

Audio


# Realtek ALC882 High Definition audio CODEC
# 8-channel audio output
# True stereo line level outputs
# S/PDIF interface

LAN


# Realtek RTL8111B PCIE Gigabit LAN
# Fully compliant to IEEE 802.3 (10BASE-T), 802.3u (100BASE-TX) and 802.3ab (1000BASE-T) standards

IDE


# Supports up to UltraDMA 100Mbps IDE devices

Serial ATA


# Intel chipset supports: - Four SATA ports - SATA speed up to 3Gb/s - RAID 0, RAID 1, RAID 0 1 and RAID 5
# JMB360 chip supports: - One eSATA (external SATA) port - SATA speed up to 3Gb/s

Rear Panel I/O Ports


# 1 mini-DIN-6 PS/2 mouse port
# 1 mini-DIN-6 PS/2 keyboard port
# 1 parallel port
# 1 optical S/PDIF-out port
# 1 RCA S/PDIF-out port
# 1 eSATA port
# 1 IEEE 1394 port
# 1 RJ45 LAN port
# 4 USB 2.0/1.1 ports
# Line-in, line-out (front R/L) and mic-in jacks
# Center/subwoofer, rear R/L and side R/L jacks

I/O Connectors


# 2 connectors for 4 additional external USB 2.0 ports
# 1 connector for 1 external IEEE 1394 port
# 2 connectors for 2 external serial ports
# 1 front audio connector for line-out and mic-in jacks
# 1 CD-in internal audio connector
# 1 connector for IrDA interface
# 4 Serial ATA connectors
# 1 40-pin IDE connector
# 1 floppy connector
# 1 24-pin ATX power connector
# 1 8-pin 12V power connector
# 1 4-pin 5V/12V power connector (FDD type)
# 1 front panel connector
# 3 fan connectors
# EZ touch switches (power switch and reset switch)



It is highly recommended to always use the most recent driver version available.
Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.