# Checksum: 2536h
# Fixed boot from LAN issue.


Specifications:


CPU: Support Intel Pentium 4 CPU
FSB 533MHz
Socket 478
Chipset: Intel ICH4
Intel 845G
Main Memory : DDR266 [PC2100]
DDR DIMM
8/16/32/64/128/256/512MB
Max Memory : 2GB
Super I/O: Winbond
Clock Gen.: Realtek
Graphics: Integrated VGA Engine in chipset
4X AGP slot
Support ADD card
IDE: Integrated ATA100 Controller
Max Disk : 144,000,000GB [by 48 bits LBA Spec.]
LAN: Integrated Realtek PHY
Integrated Realtek 10/100Mbps PCI LAN Chip
Audio: Analog Devices AC'97 Audio CODEC on-board
USB: USB 2.0 Port x 1
Slot: AGP
PCI
CNR
Storage & Back Panel I/O: IDE Channel : ATA100
Floppy Drive Connector : Floppy Drive Connector x 1
PS/2 Keyboard : x 1
PS/2 Mouse : x 1
VGA Port : x 1
Printer Port : Printer Port x 1
COM Port : COM Port x 1
USB Port : USB Port x 1
LAN Port : LAN Port x 1
Game/MIDI Port : x 1
Line_In : x 1
Speaker_Out : x 1
MIC_In : x 1
On Board Connector: CPU FAN
Chassis FAN
System FAN
USB Port
Front Audio
Front Panel Connector : Front Panel
S/PDIF Connector : S/PDIF
CD_IN Connector : CD_IN
IrDA Connector : IrDA
AUX_IN Connector : AUX_IN
COM2 Connector : COM2 Port x 1
Wake_on_LAN
Wake_on_Modem
Chassis Intrusion Connector : Case Open Connector
BIOS: Award PnP 4Mb Flash ROM BIOS
Form Factor: Micro ATX
Board Size: 244 mm x 218 mm
Software & Utility: EzWinFlash utility
EzSkin utility
EzRestore/ProMagic
SilentTek Software
Acrobat Reader
AOconfig utility
Online eBook Manual
Accessory: 80-wire IDE cable
Bonus Pack CD disc
Floppy Disk cable
Easy Installation Guide x 1
CPU Retention Module x 1
EzRestore Guide x 1



It is highly recommended to always use the most recent driver version available.
Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.